Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

capacitor question?
#5

thanks for the vote of confidence! do you think that the manual would help me chase the wiring down for this radio? the schematic seems vary confusing to me. If I could see what it is suppose to look like a lot closer up might help me. Shawn


Messages In This Thread
capacitor question? - by Guest - 10-31-2009, 05:51 PM
Re: capacitor question? - by Alan Douglas - 10-31-2009, 09:18 PM
Re: capacitor question? - by Guest - 11-01-2009, 08:03 AM
Re: capacitor question? - by codefox1 - 11-01-2009, 01:26 PM
Re: capacitor question? - by Guest - 11-01-2009, 05:02 PM
Re: capacitor question? - by gary rabbitt - 11-07-2009, 01:04 AM
Re: capacitor question? - by Guest - 11-11-2009, 02:39 PM
Re: capacitor question? - by Alan Douglas - 11-12-2009, 05:22 PM
Re: capacitor question? - by Guest - 11-17-2009, 03:28 PM
Re: capacitor question? - by exray - 11-19-2009, 08:02 AM
Re: capacitor question? - by Ron Ramirez - 11-19-2009, 09:44 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM

[-]
Who's Online
There are currently 5504 online users. [Complete List]
» 1 Member(s) | 5503 Guest(s)
Avatar

>