12-23-2016, 11:05 AM
I can see that being a problem with the grounded filament. That is a lot of voltage between the heater and cathode, and a direct B+ short to ground wouldn't be kind to the trans. I didn't see the whole schematic, but if the filament weren't grounded, wouldn't that eliminate the problem? Well, maybe, maybe not ... it could then put that across the HK of the weaker signal tubes, then one of those short, = lots of excitement. 
I have several radios that use this tube, but they all use the GT tube, not the G tube. One did have a bad power transformer - worked ok, but just ran super hot. Gradually got worse til I replaced it. Maybe was related to a failed 6X5 at some point?? 
But, even if one of the silicon diodes shorts, that wouldn't be any too kind to the trans either.
I have several radios that use this tube, but they all use the GT tube, not the G tube. One did have a bad power transformer - worked ok, but just ran super hot. Gradually got worse til I replaced it. Maybe was related to a failed 6X5 at some point?? But, even if one of the silicon diodes shorts, that wouldn't be any too kind to the trans either.
If I could find the place called "Somewhere", I could find "Anything"
Tim
Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
