1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 46-350
vecher
Phorum Expert
*****
Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA
#6

12-25-2016, 11:55 PM
Well finished recap. Started to power up on Variac.. I get no voltage anywhere no current draw either. .. Not sure if tubes are even lighting up. My guess is I have a bad tube somewhere? But shouldn't I get some voltage with only the 117Z3 rectifier tube in? See previous schematic??

Skip...
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 46-350 - by vecher - 12-01-2016, 10:15 PM
RE: Philco 46-350 - by Mondial - 12-01-2016, 10:42 PM
RE: Philco 46-350 - by vecher - 12-01-2016, 10:47 PM
RE: Philco 46-350 - by vecher - 12-24-2016, 12:41 AM
RE: Philco 46-350 - by Arran - 12-24-2016, 04:47 AM
RE: Philco 46-350 - by vecher - 12-25-2016, 11:55 PM
RE: Philco 46-350 - by Mondial - 12-26-2016, 12:41 AM
RE: Philco 46-350 - by vecher - 12-26-2016, 04:05 PM
RE: Philco 46-350 - by Mondial - 12-26-2016, 04:22 PM
RE: Philco 46-350 - by vecher - 12-26-2016, 05:20 PM
RE: Philco 46-350 - by Radioroslyn - 12-26-2016, 07:21 PM
RE: Philco 46-350 - by Kenneth F. Besso Jr. - 12-26-2016, 08:07 PM
RE: Philco 46-350 - by vecher - 12-26-2016, 08:15 PM
RE: Philco 46-350 - by vecher - 12-27-2016, 06:55 PM
RE: Philco 46-350 - by vecher - 12-27-2016, 07:48 PM
RE: Philco 46-350 - by vecher - 12-27-2016, 10:18 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM

[-]
Who's Online
There are currently 3787 online users. [Complete List]
» 1 Member(s) | 3786 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration