01-05-2017, 06:47 PM
still a long way to go but more progress today....
A dremel tool the barrel sanding tool helped get some of the burnt wood (from the router...does that mean my router bit is dull, bad technique, or just the way it goes...?)
[Image: https://www.dropbox.com/s/qf3vllh03leigt....jpg?raw=1]
Some 150 grit sandpaper wrapped on the end of a pencil eraser seemed best for sanding the bottoms of the decorative routing sections...sloooooow going!
[Image: https://www.dropbox.com/s/ws8niv107bzpzn....jpg?raw=1]
...and the door cut out of the plywood board. More work to do but getting there
[Image: https://www.dropbox.com/s/mqrl5a1iu1wqxz....jpg?raw=1]
A dremel tool the barrel sanding tool helped get some of the burnt wood (from the router...does that mean my router bit is dull, bad technique, or just the way it goes...?)
[Image: https://www.dropbox.com/s/qf3vllh03leigt....jpg?raw=1]
Some 150 grit sandpaper wrapped on the end of a pencil eraser seemed best for sanding the bottoms of the decorative routing sections...sloooooow going!
[Image: https://www.dropbox.com/s/ws8niv107bzpzn....jpg?raw=1]
...and the door cut out of the plywood board. More work to do but getting there
[Image: https://www.dropbox.com/s/mqrl5a1iu1wqxz....jpg?raw=1]
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
