1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
GE E-71 Trouble shooting ?
Radioroslyn
Phorum Expert
*****
Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#7

01-08-2017, 07:38 PM
Ok So check R-17 (supplies the plate voltage for the 2nd IF amp)
Check L-10 and L-15 for open winding and the associated switch contacts.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
GE E-71 Trouble shooting ? - by Eric - 01-08-2017, 01:22 PM
RE: GE E-71 Trouble shooting ? - by KCMike - 01-08-2017, 02:10 PM
RE: GE E-71 Trouble shooting ? - by Radioroslyn - 01-08-2017, 03:37 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-08-2017, 04:53 PM
RE: GE E-71 Trouble shooting ? - by Radioroslyn - 01-08-2017, 05:14 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-08-2017, 05:31 PM
RE: GE E-71 Trouble shooting ? - by Radioroslyn - 01-08-2017, 07:38 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-09-2017, 11:57 AM
RE: GE E-71 Trouble shooting ? - by Mondial - 01-09-2017, 12:32 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-09-2017, 03:54 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-10-2017, 12:03 PM
RE: GE E-71 Trouble shooting ? - by Mondial - 01-10-2017, 12:27 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-10-2017, 02:33 PM
RE: GE E-71 Trouble shooting ? - by Mondial - 01-10-2017, 02:52 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-12-2017, 01:31 PM
RE: GE E-71 Trouble shooting ? - by Radioroslyn - 01-12-2017, 01:59 PM
RE: GE E-71 Trouble shooting ? - by klondike98 - 01-12-2017, 02:19 PM
RE: GE E-71 Trouble shooting ? - by Eric - 01-19-2017, 10:16 AM
RE: GE E-71 Trouble shooting ? - by Eliot Ness - 01-19-2017, 11:11 AM
RE: GE E-71 Trouble shooting ? - by KCMike - 01-19-2017, 11:36 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM

[-]
Who's Online
There are currently 4353 online users. [Complete List]
» 4 Member(s) | 4349 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)