Philco model 87

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco model 87

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#14

01-09-2017, 11:42 AM

(01-04-2017, 11:08 PM)flatheadjr Wrote: Not quite sure what these are they look like a resistor, capacitor mix, across the top of them I get 100 ohms or very close to that, the other part is the capacitor that goes to ground.

http://rs32.pbsrc.com/albums/d5/flathead...0&fit=clip

That pic isn't from a 77 chassis it has the wrong tubes in it, it looks to be a 87. According to the schematic the 77 doesn't use those decoupling resistor/capacitor. The pic in the beginning of the thread is a 77.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

(This post was last modified: 01-09-2017, 11:43 AM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco model 87 - by flatheadjr - 09-28-2016, 09:27 PM

RE: Philco model 87 - by flatheadjr - 01-11-2017, 09:24 PM

RE: Philco model 87 - by flatheadjr - 01-21-2017, 04:40 PM

RE: Philco model 87 - by Radioroslyn - 01-21-2017, 07:44 PM

RE: Philco model 87 - by Mondial - 01-21-2017, 09:34 PM

RE: Philco model 87 - by flatheadjr - 01-21-2017, 09:52 PM

RE: Philco model 87 - by Radioroslyn - 01-22-2017, 12:07 AM

RE: Philco model 87 - by flatheadjr - 01-22-2017, 12:30 AM

RE: Philco model 87 - by Radioroslyn - 01-22-2017, 07:10 AM

RE: Philco model 87 - by flatheadjr - 01-22-2017, 02:16 PM

RE: Philco model 87 - by Radioroslyn - 01-22-2017, 03:11 PM

RE: Philco model 87 - by flatheadjr - 01-22-2017, 03:48 PM

RE: Philco model 87 - by Radioroslyn - 01-23-2017, 01:25 AM

RE: Philco model 87 - by flatheadjr - 01-23-2017, 01:37 AM

RE: Philco model 87 - by Radioroslyn - 01-23-2017, 01:11 PM

RE: Philco model 77 - by Radioroslyn - 09-29-2016, 10:29 AM

RE: Philco model 77 - by flatheadjr - 09-29-2016, 12:17 PM

RE: Philco model 77 - by Arran - 10-01-2016, 05:00 AM

RE: Philco model 77 - by flatheadjr - 10-08-2016, 06:22 PM

RE: Philco model 77 - by Radioroslyn - 10-08-2016, 08:05 PM

RE: Philco model 77 - by flatheadjr - 10-12-2016, 09:31 PM

RE: Philco model 77 - by Radioroslyn - 10-12-2016, 10:35 PM

RE: Philco model 77 - by Radioroslyn - 10-17-2016, 08:05 PM

RE: Philco model 77 - by flatheadjr - 01-04-2017, 11:08 PM

RE: Philco model 77 - by Radioroslyn - 01-05-2017, 10:30 AM

RE: Philco model 77 - by flatheadjr - 01-05-2017, 09:46 PM

RE: Philco model 77 - by Arran - 01-09-2017, 04:02 AM

RE: Philco model 77 - by Radioroslyn - 01-09-2017, 11:42 AM

RE: Philco model 77 - by flatheadjr - 01-11-2017, 12:03 AM

RE: Philco model 77 - by Ron Ramirez - 01-11-2017, 01:20 PM

RE: Philco model 77 - by Radioroslyn - 01-11-2017, 09:03 AM

View a Printable Version

Users browsing this thread: 8 Guest(s)

Recent Posts
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W 1.5k ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM

Who's Online

There are currently 6234 online users. [Complete List]
» 4 Member(s) | 6230 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me