1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
FM Alignment of 48-482
Sean
Member
***
Posts: 151
Threads: 5
Joined: Oct 2005
City: Sullivan, MO
#4

12-05-2009, 05:21 PM
Well I did the alignment again this time by using over-the-air stations. I think it will be close enough for my use. There is a station at 88.1 that I listen to regularly and trying to get the dial aligned to pick it up as well as stuff at the upper end of the dial was kind of tricky. Now I just have to figure out why I am getting hum in the audio of weak AM and SW signals.
Sean
WØKPX
Find
« Next Oldest | Next Newest »


Messages In This Thread
FM Alignment of 48-482 - by Sean - 11-21-2009, 11:06 AM
Re: FM Alignment of 48-482 - by Ron Ramirez - 12-01-2009, 08:29 AM
Re: FM Alignment of 48-482 - by Terry Judkins - 12-03-2009, 10:53 PM
Re: FM Alignment of 48-482 - by Sean - 12-05-2009, 05:21 PM
Re: FM Alignment of 48-482 - by DCASAZZA - 12-10-2009, 09:38 AM
Re: FM Alignment of 48-482 - by Don Lind - 12-12-2009, 02:27 PM
Re: FM Alignment of 48-482 - by Sean - 01-05-2010, 09:50 AM
Re: FM Alignment of 48-482 - by Ron Ramirez - 01-05-2010, 11:08 AM
Re: FM Alignment of 48-482 - by Sean - 01-09-2010, 02:08 PM
Re: FM Alignment of 48-482 - by Ron Ramirez - 01-09-2010, 03:06 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration