Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco B572
#4

Use a small flat tipped screwdriver. Insert it over one of the rivets. Give the screwdriver a little twist forcing the shield upward. Should pop right off.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco B572 - by vecher - 01-20-2017, 10:13 PM
RE: Philco B572 - by morzh - 01-20-2017, 10:45 PM
RE: Philco B572 - by Arran - 01-21-2017, 06:19 AM
RE: Philco B572 - by Radioroslyn - 01-21-2017, 08:41 AM
RE: Philco B572 - by OldRestorer - 01-21-2017, 11:01 AM
RE: Philco B572 - by vecher - 01-21-2017, 06:23 PM
RE: Philco B572 - by vecher - 01-25-2017, 06:02 PM
RE: Philco B572 - by vecher - 01-28-2017, 03:38 PM
RE: Philco B572 - by vecher - 01-29-2017, 12:29 AM
RE: Philco B572 - by klondike98 - 01-29-2017, 11:29 AM
RE: Philco B572 - by vecher - 01-31-2017, 11:17 AM
RE: Philco B572 - by klondike98 - 01-31-2017, 01:10 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Butting in here with a question. Since the shadow meter is connected directly to the 1st and 2nd I.F.'s wouldn't the met...RossH — 06:43 PM
HiFi (Chifi) tube amp build - but my own design.
Mike, Tim; you are about to enter the twilight zone. Doo doo doo doo, doo doo doo doo This is something alright. I'm go...RodB — 06:26 PM
HiFi (Chifi) tube amp build - but my own design.
:lol: We need to start a singing radio group! I play the guitar, so maybe get a few vocals? Anyways, Mike, I did try mou...TV MAN — 05:56 PM
HiFi (Chifi) tube amp build - but my own design.
And so does a barber shop quartet. mmmmmmRodB — 03:54 PM
Shadow Meter Bulb
I did try an LED bulb in place of the original but wasn't impressed with the amount of light on the dial. Seems like it ...RodB — 03:51 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Would mounting he transformer vertically change the hum, if used without additional parts? Also, in these amps...morzh — 02:25 PM
Shadow Meter Bulb
Gary I doubt it would introduce any noise. We use similar lamps for the panel indication, 12V AC lamps: they are LEDs...morzh — 02:15 PM
Shadow Meter Bulb
Not sure if anyone has tried this but there are 6.3 volt miniature lamps in bayonet and screw-in base options available ...GarySP — 11:31 AM
Shadow Meter Bulb
Any 6.3 volt pilot light will work. I would use the brightest one I could find in my workroom. Be sure the dial is clean...RodB — 10:45 AM
HiFi (Chifi) tube amp build - but my own design.
Tim, nice write up and thanks for sharing !! Sincerely Richardradiorich — 02:47 AM

[-]
Who's Online
There are currently 6877 online users. [Complete List]
» 1 Member(s) | 6876 Guest(s)
Avatar

>