1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco model 87
flatheadjr
Member
***
Posts: 135
Threads: 14
Joined: Mar 2016
City: Idaho Falls, Idaho
#26

01-22-2017, 02:16 PM
Okay so what I did was disconnect the center tap wire of the controller off of the coil so I could isolate the coil and the volume control. There are only 2 connections on that coil that sit up inside the can. When I measure that it reads 3.2 ohms. If I measure the control with the volume up all the way up, from the wire I disconnected I get a measurement of 10.5k and that's only the controller.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco model 87 - by flatheadjr - 09-28-2016, 09:27 PM
RE: Philco model 87 - by flatheadjr - 01-11-2017, 09:24 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 04:40 PM
RE: Philco model 87 - by Radioroslyn - 01-21-2017, 07:44 PM
RE: Philco model 87 - by Mondial - 01-21-2017, 09:34 PM
RE: Philco model 87 - by flatheadjr - 01-21-2017, 09:52 PM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 12:07 AM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 12:30 AM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 07:10 AM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 02:16 PM
RE: Philco model 87 - by Radioroslyn - 01-22-2017, 03:11 PM
RE: Philco model 87 - by flatheadjr - 01-22-2017, 03:48 PM
RE: Philco model 87 - by Radioroslyn - 01-23-2017, 01:25 AM
RE: Philco model 87 - by flatheadjr - 01-23-2017, 01:37 AM
RE: Philco model 87 - by Radioroslyn - 01-23-2017, 01:11 PM
RE: Philco model 77 - by Radioroslyn - 09-29-2016, 10:29 AM
RE: Philco model 77 - by flatheadjr - 09-29-2016, 12:17 PM
RE: Philco model 77 - by Arran - 10-01-2016, 05:00 AM
RE: Philco model 77 - by flatheadjr - 10-08-2016, 06:22 PM
RE: Philco model 77 - by Radioroslyn - 10-08-2016, 08:05 PM
RE: Philco model 77 - by flatheadjr - 10-12-2016, 09:31 PM
RE: Philco model 77 - by Radioroslyn - 10-12-2016, 10:35 PM
RE: Philco model 77 - by Radioroslyn - 10-17-2016, 08:05 PM
RE: Philco model 77 - by flatheadjr - 01-04-2017, 11:08 PM
RE: Philco model 77 - by Radioroslyn - 01-05-2017, 10:30 AM
RE: Philco model 77 - by flatheadjr - 01-05-2017, 09:46 PM
RE: Philco model 77 - by Arran - 01-09-2017, 04:02 AM
RE: Philco model 77 - by Radioroslyn - 01-09-2017, 11:42 AM
RE: Philco model 77 - by flatheadjr - 01-11-2017, 12:03 AM
RE: Philco model 77 - by Ron Ramirez - 01-11-2017, 01:20 PM
RE: Philco model 77 - by Radioroslyn - 01-11-2017, 09:03 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W  1.5k  ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio.  This is a shame because this should be a good performer.  2A5...MrFixr55 — 06:48 AM
American Bosch Model 802 auto radio
I think it would come under either American Bosch or United American Bosch. American Bosch made sets for the American We...Arran — 05:53 AM
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM

[-]
Who's Online
There are currently 6079 online users. [Complete List]
» 2 Member(s) | 6077 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration