Stuffing a 70 Can

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Stuffing a 70 Can

Guest
Unregistered

12-10-2009, 11:12 PM

I'm a newbe to this forum so I appreciate the ability to tap into the available talent. Anyway, I have an early 70 chassis with the lytic cans that have a stud with nut for wire terminals and a large 1 1/8 nut that fastens it to chassis. It has 2 vent holes on flat top. Not sure on best way to open it up; any suggestions? It looks like I could attempt to open at bottom around base were it is crimped or cut it in two somewhere up on cylinder. Thanks for any help; I'm sure I'll be here again for more help before I get this playing. Bill

« Next Oldest | Next Newest »

Messages In This Thread

Stuffing a 70 Can - by Guest - 12-10-2009, 11:12 PM

Re: Stuffing a 70 Can - by Music in a bottle - 12-11-2009, 02:48 AM

Re: Stuffing a 70 Can - by Terry Burns - 12-11-2009, 09:11 AM

Re: Stuffing a 70 Can - by Guest - 12-11-2009, 11:31 AM

Re: Stuffing a 70 Can - by Ron Ramirez - 12-11-2009, 12:47 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online

There are currently 5481 online users. [Complete List]
» 2 Member(s) | 5479 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me