1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco-Transitone Auto Radios
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
67 mustang Philco model 7TPZ
Guest
Unregistered
 
#4

12-23-2009, 01:40 AM
Thanks for the responses. What I finally figured out is that the gear assembly that passes through the pressure plate was broken. This allowed the gear to spin freely without moving the pressure plate so no force was put on the rubber washer. I was able to glue the two together and now it holds and allows the pressure to be transmitted to the tuning mechanism allowing it to work. Hope this helps someone as I now have a few of these radios and it seems to be a common problem. Thanks again for the replys!
« Next Oldest | Next Newest »


Messages In This Thread
67 mustang Philco model 7TPZ - by Guest - 11-19-2009, 01:53 AM
Re: 67 mustang Philco model 7TPZ - by Don Lind - 11-26-2009, 02:07 PM
Re: 67 mustang Philco model 7TPZ - by BILL - 11-28-2009, 01:11 PM
Re: 67 mustang Philco model 7TPZ - by Guest - 12-23-2009, 01:40 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
IF can wire size and Rubber mounts?
Hello PHORUM members, I am still working on restoration of my PHILCO 37-640.  I want to start with rewiring the IF ca...georgetownjohn — 06:32 PM
Gilfillan Brothers Car Radio?
There is a Mission Bell model 19/19A that could be what you’re looking for, Riders vol 4. It has the tube line-up of: 0Z...Joe Rossi — 05:01 PM
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the  5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM

[-]
Who's Online
There are currently 3122 online users. [Complete List]
» 2 Member(s) | 3120 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco-Transitone Auto Radios