1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco model 610
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#31

02-08-2017, 09:40 PM
(02-08-2017, 08:54 PM)keith49vj3 Wrote:  Just to be sure, you're getting 1100 ohms when you test your field coil by putting your ohmmeter across the positive terminals of the two 8uf caps?
Keith

If you can get ac hum from touching the cap of the 75 then the choke is conducting. If not there wouldn't be any HV throughout the chassis except for at the filament of the 80.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 02-08-2017, 09:41 PM by Radioroslyn.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco model 610 - by Radio Hound - 01-17-2017, 08:14 PM
RE: Philco model 610 - by rck46 - 01-17-2017, 08:50 PM
RE: Philco model 610 - by Radioroslyn - 01-17-2017, 11:07 PM
RE: Philco model 610 - by Radio Hound - 01-18-2017, 08:01 PM
RE: Philco model 610 - by morzh - 01-18-2017, 08:16 PM
RE: Philco model 610 - by Radio Hound - 01-19-2017, 08:09 AM
RE: Philco model 610 - by Radioroslyn - 01-18-2017, 08:21 PM
RE: Philco model 610 - by Radio Hound - 01-19-2017, 08:13 AM
RE: Philco model 610 - by Radioroslyn - 01-19-2017, 08:25 AM
RE: Philco model 610 - by Radio Hound - 01-19-2017, 12:12 PM
RE: Philco model 610 - by morzh - 01-19-2017, 12:52 PM
RE: Philco model 610 - by Radio Hound - 01-19-2017, 01:09 PM
RE: Philco model 610 - by morzh - 01-19-2017, 02:31 PM
RE: Philco model 610 - by Mondial - 01-19-2017, 06:53 PM
RE: Philco model 610 - by Radio Hound - 01-20-2017, 11:45 AM
RE: Philco model 610 - by Radio Hound - 01-23-2017, 04:54 PM
RE: Philco model 610 - by morzh - 01-23-2017, 04:59 PM
RE: Philco model 610 - by Radio Hound - 01-23-2017, 05:02 PM
RE: Philco model 610 - by morzh - 01-23-2017, 05:03 PM
RE: Philco model 610 - by Radio Hound - 01-23-2017, 05:18 PM
RE: Philco model 610 - by morzh - 01-23-2017, 05:19 PM
RE: Philco model 610 - by Radio Hound - 01-23-2017, 05:24 PM
RE: Philco model 610 - by morzh - 01-23-2017, 05:35 PM
RE: Philco model 610 - by Radio Hound - 02-07-2017, 01:16 PM
RE: Philco model 610 - by morzh - 02-07-2017, 04:15 PM
RE: Philco model 610 - by Radio Hound - 02-07-2017, 04:50 PM
RE: Philco model 610 - by Radio Hound - 02-07-2017, 04:59 PM
RE: Philco model 610 - by morzh - 02-07-2017, 06:17 PM
RE: Philco model 610 - by keith49vj3 - 02-08-2017, 08:54 PM
RE: Philco model 610 - by Radioroslyn - 02-08-2017, 09:40 PM
RE: Philco model 610 - by keith49vj3 - 02-08-2017, 09:01 PM
RE: Philco model 610 - by keith49vj3 - 02-09-2017, 07:48 AM
RE: Philco model 610 - by klondike98 - 02-09-2017, 11:07 AM
RE: Philco model 610 - by TV MAN - 02-13-2017, 01:08 PM
RE: Philco model 610 - by Radio Hound - 02-13-2017, 06:04 PM
RE: Philco model 610 - by keith49vj3 - 02-13-2017, 09:13 PM
RE: Philco model 610 - by Radio Hound - 02-16-2017, 05:24 PM
RE: Philco model 610 - by keith49vj3 - 02-13-2017, 09:33 PM
RE: Philco model 610 - by keith49vj3 - 02-14-2017, 09:56 PM
RE: Philco model 610 - by keith49vj3 - 02-15-2017, 07:46 AM
RE: Philco model 610 - by keith49vj3 - 02-16-2017, 09:22 PM
RE: Philco model 610 - by morzh - 02-16-2017, 11:56 PM
RE: Philco model 610 - by keith49vj3 - 02-17-2017, 08:13 AM
RE: Philco model 610 - by morzh - 02-17-2017, 09:58 AM
RE: Philco model 610 - by keith49vj3 - 02-19-2017, 08:23 AM
RE: Philco model 610 - by morzh - 02-19-2017, 12:08 PM
RE: Philco model 610 - by Radio Hound - 02-20-2017, 08:35 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM

[-]
Who's Online
There are currently 3236 online users. [Complete List]
» 3 Member(s) | 3233 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration