Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 51-931 tubes
#9

Just thought I would show the radio in question, it is completed.        


Attached Files Image(s)
       

Jim
Spring Lake MI


Messages In This Thread
Philco 51-931 tubes - by Jimradio - 02-11-2017, 08:08 AM
RE: Philco 51-931 tubes - by Jim Koehler - 02-11-2017, 12:33 PM
RE: Philco 51-931 tubes - by morzh - 02-11-2017, 01:18 PM
RE: Philco 51-931 tubes - by Jimradio - 02-11-2017, 08:21 PM
RE: Philco 51-931 tubes - by Jimradio - 02-12-2017, 07:45 AM
RE: Philco 51-931 tubes - by Jimradio - 02-14-2017, 09:59 AM
RE: Philco 51-931 tubes - by Mondial - 02-14-2017, 10:38 AM
RE: Philco 51-931 tubes - by Jimradio - 02-15-2017, 07:55 AM
RE: Philco 51-931 tubes - by Jimradio - 02-15-2017, 09:27 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 3239 online users. [Complete List]
» 1 Member(s) | 3238 Guest(s)
Avatar

>