Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

42-321 Alignment problem.
#4

FStephenMasek Wrote:Mine also had a defective oscillator coil - there is a dead end wiring which serves as a capacitor, and it had become open..

Don'tcha hate it when an open coil winding goes open? How did you locate that?


Messages In This Thread
42-321 Alignment problem. - by Guest - 12-17-2009, 07:53 PM
Re: 42-321 Alignment problem. - by Guest - 12-17-2009, 08:41 PM
Re: 42-321 Alignment problem. - by FStephenMasek - 12-21-2009, 01:04 AM
Re: 42-321 Alignment problem. - by exray - 12-21-2009, 06:15 AM
Re: 42-321 Alignment problem. - by FStephenMasek - 12-31-2009, 01:07 AM
Re: 42-321 Alignment problem. - by 7estatdef - 12-31-2009, 06:36 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Samlex heavy-Duty bench supply filter question
Hello Everyone, I have one of my Heavy-duty bench powersuplies made by Samlex it's 13.8 volt dc 20-25 amp supply. What I...radiorich — 11:24 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
It's a Glaser Sears changer which Philco's engineers thought was an upgrade over a VM, but in retrospect I'd prefer the ...jeibner — 10:39 PM
AC/DC Transformer-less Sets
Joseph, Thank you for the confirmation. I knew that there must be more to the Transformer-less AC/DC radios than the ...PeterN — 10:30 PM
AC/DC Transformer-less Sets
Good evening, folks. Power station engineer here! The east coast had pockets of DC-only power well into the twentieth...jrblasde — 10:11 PM
AC/DC Transformer-less Sets
Model 40 does not have a rectifier, so it would be a DC only model. This however does not say anything about using...morzh — 08:01 PM
AC/DC Transformer-less Sets
I was wondering if anyone knows if these AC/DC transformer-less sets were actually used on 110v DC anywhere, and when. ...PeterN — 06:35 PM
Looking for place to donate unique Philco Philco J-1930 Prototype
Given the 1960s vintage, it is likely that the cartridge is ceramic, likely more stable. The changer looks like a Voice...MrFixr55 — 05:03 PM
Jackson 665 j2 schematic request
FIXED!daveone23 — 03:55 PM
Bakelite crack repair - what is best epoxy?
Thanks everyone. I appreciate you sharing your experience and looks like I'll work with the 24 hr two part clear epoxy....de371 — 10:25 PM
Jackson 665 j2 schematic request
Without a schematic its going to be hard tracing the wire wound spool resistors.daveone23 — 05:21 PM

[-]
Who's Online
There are currently 4030 online users. [Complete List]
» 1 Member(s) | 4029 Guest(s)
Avatar

>