Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco "Super" 19
#2

Lurking

This should be a great thread! I came very close to doing that with a model 19B last weekend...but finally, after a very long alignment session, it straightened out and began tracking properly across the band.

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Philco "Super" 19 - by Steve Davis - 03-31-2017, 12:01 AM
RE: Philco "Super" 19 - by Ron Ramirez - 03-31-2017, 06:03 AM
RE: Philco "Super" 19 - by Kenneth F. Besso Jr. - 03-31-2017, 08:32 PM
RE: Philco "Super" 19 - by jcassity - 03-31-2017, 09:50 PM
RE: Philco "Super" 19 - by Mondial - 04-01-2017, 12:17 AM
RE: Philco "Super" 19 - by Arran - 04-01-2017, 04:16 AM
RE: Philco "Super" 19 - by Ron Ramirez - 04-01-2017, 07:40 AM
RE: Philco "Super" 19 - by Steve Davis - 04-01-2017, 08:58 AM
RE: Philco "Super" 19 - by Steve Davis - 04-03-2017, 04:28 PM
RE: Philco "Super" 19 - by Steve Davis - 04-03-2017, 06:21 PM
RE: Philco "Super" 19 - by KCMike - 04-03-2017, 07:53 PM
RE: Philco "Super" 19 - by morzh - 04-03-2017, 08:08 PM
RE: Philco "Super" 19 - by Steve Davis - 04-03-2017, 09:53 PM
RE: Philco "Super" 19 - by morzh - 04-03-2017, 11:15 PM
RE: Philco "Super" 19 - by 462ron - 04-04-2017, 03:02 PM
RE: Philco "Super" 19 - by Steve Davis - 04-05-2017, 12:46 AM
RE: Philco "Super" 19 - by markmokris - 04-06-2017, 11:41 PM
RE: Philco "Super" 19 - by Steve Davis - 04-20-2017, 05:38 PM
RE: Philco "Super" 19 - by morzh - 04-20-2017, 09:51 PM
RE: Philco "Super" 19 - by gregb - 04-20-2017, 09:59 PM
RE: Philco "Super" 19 - by Ron Ramirez - 05-18-2017, 12:39 PM
RE: Philco "Super" 19 - by Steve Davis - 05-19-2017, 11:57 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>