1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Frayed Wires at Speaker Plug
Guest
Unregistered
 
#1

01-07-2010, 09:59 PM
The Philco 70 I'm restoring( at least attempting) has bare, frayed speaker wires at the male 4 prong connector that plugs into the rear of chassis. Can I drill out the two rivets,separate the plug and then cut and resolder the wires were the insulation is still good? If this will not work maybe I can cut off the plug and replace with a 4 pin "CP" plug? Thanks in advance for your help.
Bill
« Next Oldest | Next Newest »


Messages In This Thread
Frayed Wires at Speaker Plug - by Guest - 01-07-2010, 09:59 PM
Re: Frayed Wires at Speaker Plug - by Ron Ramirez - 01-07-2010, 10:55 PM
Re: Frayed Wires at Speaker Plug - by Allen in SB - 01-07-2010, 11:01 PM
Re: Frayed Wires at Speaker Plug - by Guest - 01-08-2010, 01:54 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

[-]
Who's Online
There are currently 5610 online users. [Complete List]
» 2 Member(s) | 5608 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration