Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

40-180 veneer
#1

I would like to do some veneer repair in a few spots on the top of my 40-180.
Can anyone suggest a place where I can purchase the proper veneer to use.
From some previous posts I have read, I believe I need Walnut ?
The cabinet has been shellacked at some time in it's life but I need to repair these issues first.
I measured the thickness at around .030"
I appreciate any assistance with this, this is my first post and my first Philco.
Thank you,
Jerry


Attached Files Image(s)
   


Messages In This Thread
40-180 veneer - by jeryb - 04-14-2017, 05:24 PM
RE: 40-180 veneer - by Arran - 04-15-2017, 10:14 PM
RE: 40-180 veneer - by jeryb - 04-15-2017, 10:22 PM
RE: 40-180 veneer - by John Bartley - 04-16-2017, 07:59 AM
RE: 40-180 veneer - by jeryb - 04-16-2017, 11:24 PM
RE: 40-180 veneer - by Arran - 04-17-2017, 09:11 PM
RE: 40-180 veneer - by jeryb - 04-17-2017, 09:51 PM
RE: 40-180 veneer - by Arran - 04-17-2017, 11:36 PM
RE: 40-180 veneer - by Steve Davis - 04-17-2017, 10:48 PM
RE: 40-180 veneer - by Mondial - 04-18-2017, 07:47 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Correct model 84 Ac plug an cord type
From what I read Philco went to using brown rubber power cords in 1936, so cloth was used in the 1935 and earlier models...Arran — 11:25 PM
Correct model 84 Ac plug an cord type
Hi Bruce, I have not worked on an 84, but in general, power cords for almost any radio prior to 1938 was cloth covered...MrFixr55 — 08:34 PM
Restoring Philco 38-14
OK, well, so after staring at the sch again, I realized the problem had to be the #12/12A padder. I put a scope on the o...morzh — 08:15 PM
Correct model 84 Ac plug an cord type
Hello Bruce, I mostly use brown far as my cloth powercords go ! Here is the plug that I have used bakelite Acorn style...radiorich — 08:05 PM
Correct model 84 Ac plug an cord type
Looking for as correct as can find the right Ac plug an the correct colored cloth line. Ive seen many old photos but mos...Bruce — 04:13 PM
Restoring Philco 38-14
Rod Two Y-caps make sense if you use them from L/N to the chassis; this is only makes sense in the transformer radios...morzh — 10:11 AM
Restoring Philco 38-14
Mike, I'm curious about a specific use of he Y cap. Lately I've seen a single cap across the power transformer primary. ...RodB — 09:01 AM
Restoring Philco 38-14
hello morzh , That sounds like a plan ! Sincerely Richardradiorich — 07:45 AM
Restoring Philco 38-14
Richard, It helped some, but I still had the whining when engaging the rear power strip (I did not realize it was fro...morzh — 07:07 AM
Restoring Philco 38-14
Hello morzh, Yes , that dreaded hum in my room where i do alighment I have my cable modem and router plus desktop plus ...radiorich — 11:25 PM

[-]
Who's Online
There are currently 4375 online users. [Complete List]
» 1 Member(s) | 4374 Guest(s)
Avatar

>