1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
40-180 veneer
John Bartley
Senior Member
****
Posts: 358
Threads: 4
Joined: Aug 2015
City: Monteith, Ontario CA
#4

04-16-2017, 08:59 AM
On flat (plain) sawn wood you can see the "face" grain.  On true quarter sawn wood you can see the growth rings.

Here's an example of two cuts ("slab" = flat or plain) :

[Image: http://d2vhprqki2fot3.cloudfront.net/exp...qsawn2.jpg]
Find
« Next Oldest | Next Newest »


Messages In This Thread
40-180 veneer - by jeryb - 04-14-2017, 06:24 PM
RE: 40-180 veneer - by Arran - 04-15-2017, 11:14 PM
RE: 40-180 veneer - by jeryb - 04-15-2017, 11:22 PM
RE: 40-180 veneer - by John Bartley - 04-16-2017, 08:59 AM
RE: 40-180 veneer - by jeryb - 04-17-2017, 12:24 AM
RE: 40-180 veneer - by Arran - 04-17-2017, 10:11 PM
RE: 40-180 veneer - by jeryb - 04-17-2017, 10:51 PM
RE: 40-180 veneer - by Arran - 04-18-2017, 12:36 AM
RE: 40-180 veneer - by Steve Davis - 04-17-2017, 11:48 PM
RE: 40-180 veneer - by Mondial - 04-18-2017, 08:47 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration