40-180 veneer

Thread Rating:

40-180 veneer

Mondial
Phorum Expert

Posts: 1,114
Threads: 14
Joined: Feb 2013
City: Irvington, NY

#10

04-18-2017, 08:47 AM

Jerry, PM me with your address and I can send you some small scraps of walnut veneer from old cabinets.

Find

« Next Oldest | Next Newest »

Messages In This Thread

40-180 veneer - by jeryb - 04-14-2017, 06:24 PM

RE: 40-180 veneer - by Arran - 04-15-2017, 11:14 PM

RE: 40-180 veneer - by jeryb - 04-15-2017, 11:22 PM

RE: 40-180 veneer - by jeryb - 04-17-2017, 12:24 AM

RE: 40-180 veneer - by Arran - 04-17-2017, 10:11 PM

RE: 40-180 veneer - by jeryb - 04-17-2017, 10:51 PM

RE: 40-180 veneer - by Arran - 04-18-2017, 12:36 AM

RE: 40-180 veneer - by Steve Davis - 04-17-2017, 11:48 PM

RE: 40-180 veneer - by Mondial - 04-18-2017, 08:47 AM

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.