1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
crosley model 148 cap question
gregb
Senior Member
****
Posts: 599
Threads: 24
Joined: Jan 2014
City: Edmonton AB CA
#2

04-19-2017, 09:48 PM
From what I see Murf they should both be .1uf caps with the common of the two connected to pin 3 of the 57 tube and pin 5 of the 58 tube. Then the other side of one goes to common and the other goes to the junction of resistor 38 1 meg and resistor 67 40K. That should do it.

Gregb
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
crosley model 148 cap question - by murf - 04-19-2017, 09:16 PM
RE: crosley model 148 cap question - by gregb - 04-19-2017, 09:48 PM
RE: crosley model 148 cap question - by murf - 04-19-2017, 10:25 PM
RE: crosley model 148 cap question - by murf - 04-19-2017, 11:02 PM
RE: crosley model 148 cap question - by gregb - 04-19-2017, 11:09 PM
RE: crosley model 148 cap question - by murf - 04-19-2017, 11:29 PM
RE: crosley model 148 cap question - by murf - 04-20-2017, 03:59 PM
RE: crosley model 148 cap question - by gregb - 04-20-2017, 07:00 PM
RE: crosley model 148 cap question - by murf - 04-20-2017, 07:24 PM
RE: crosley model 148 cap question - by murf - 04-20-2017, 08:45 PM
RE: crosley model 148 cap question - by David - 04-20-2017, 08:56 PM
RE: crosley model 148 cap question - by murf - 04-20-2017, 10:00 PM



Users browsing this thread:
[-]
Recent Posts
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM
Zenith H725
I think the problem is traced - to noise on the AC line. It sounded so local, that it seemed certain it was generated wi...EdHolland — 05:51 PM
The list of my radio & TV collection!
A little bit of positivity in our feed... My new video... Test - the Philco 16B vs Philco 37-116 de Luxe / Test - the ...RadioSvit — 12:14 PM
Refinishing Ideas
Thanks. I will look into. Billpoulsbobill — 11:23 AM
My Philco 37-116 Restore
Why do the flood lights have 2 wires running to the shell of each light when the inner conductor only has one to each? ...dconant — 10:54 AM
Philco 46-480 Electronic Restoration
OOPS!! if there is a "flag" running up the side of the tube that touches the shield, then yes, a shield belon...MrFixr55 — 10:03 AM
Philco 46-480 Electronic Restoration
Thanks for pointing out that shield! I will try to find out where else it may belong. I simply installed it back where i...jrblasde — 10:02 AM

[-]
Who's Online
There are currently 710 online users. [Complete List]
» 6 Member(s) | 704 Guest(s)
AvatarAvatarAvatarAvatar
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)