04-29-2017, 03:43 PM
jumper wire bypass of this 300ohm resistor yielded about 500v on pin 3 of both 6k6's
they ramped up then came back down to somewhere around 325v on each 6k6.. way too much.
with a 500ohm resistor installed, there is an 11volt drop.
with 500 ohms in the ckt, v7 pin 3 was at 206vdc, pin 3 of v6 was at 217vdc
they ramped up then came back down to somewhere around 325v on each 6k6.. way too much.
with a 500ohm resistor installed, there is an 11volt drop.
with 500 ohms in the ckt, v7 pin 3 was at 206vdc, pin 3 of v6 was at 217vdc