46-1226 code 125 restoratioin *DONE
Posts: 15,818
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
If needs to be measured very accurately, the voltage across the resistor can be measured on AC, then on DC, then the results are squared, summed and the square root extracted. That willbe the RMS of the voltage. Before extracting the root, same sum of the squares times 300 ohm is the power dissipated.
Again, only possible with true RMS DMM, else the averaging DMM can gve anywhere 10 to 40% error on complex AC forms.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
(This post was last modified: 04-30-2017, 01:17 PM by morzh.)
Messages In This Thread
RE: 46-1226 code 125 restoratioin - by morzh - 04-30-2017, 10:20 AM
Users browsing this thread: 17 Guest(s)
|
Recent Posts
|
Philco 46-420 Code 121 Reception issues
|
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
Philco 42-1008 conversion kit
|
Interesting. I haven't seen that before.klondike98 — 07:02 PM |
12' Philco
|
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
Shadow Meter Bulb
|
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
Shadow Meter Bulb
|
Ok. Thanks for the correction.RossH — 03:09 PM |
Model 28L
|
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM |
37-60 revision 6
|
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM |
Shadow Meter Bulb
|
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM |
Hickok AC51 tube tester
|
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM |
Model 28L
|
Hello,
I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020.
Can...HORSTE — 10:32 AM |
Who's Online
|
There are currently no members online. |
|
|