46-1226 code 125 restoratioin *DONE
Posts: 619
Threads: 42
Joined: Mar 2017
City: Gap Mills Wv 24941
its not connected directly to ground.
the green center tap is tied to the filter cap Negative leads of C101 and then to one side of the r100 candohm.
what voltage would you want to see there?
Hows about i remove V8 rectifier tube,
lift off the transformer green from the terminal strip
measure the green wire to chassis?
Messages In This Thread
RE: 46-1226 code 125 restoratioin - by jcassity - 05-02-2017, 09:16 AM
Users browsing this thread: 36 Guest(s)
|
Recent Posts
|
Philco 46-420 Code 121 Reception issues
|
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
Philco 42-1008 conversion kit
|
Interesting. I haven't seen that before.klondike98 — 07:02 PM |
12' Philco
|
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
Shadow Meter Bulb
|
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
Shadow Meter Bulb
|
Ok. Thanks for the correction.RossH — 03:09 PM |
Model 28L
|
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM |
37-60 revision 6
|
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM |
Shadow Meter Bulb
|
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM |
Hickok AC51 tube tester
|
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM |
Model 28L
|
Hello,
I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020.
Can...HORSTE — 10:32 AM |
Who's Online
|
There are currently no members online. |
|
|