[jcassity]

i posted it a few posts  back ,, not sure if it was improper to do so since i had to get it from the philco workbench.
you can not use this diagram as a stand alone for any 46-1226 code 125 because there are a lot of big and small changes,, which i posted in other posts... i bundled all the changes into one picture so you see the progression from code 121, code 122 and code 125.

here it is

like pin 7 is supposed to be the shown value but i have 13.5v
Pin 6 is i think ridiing close to 300v..

some voltage readings are very dead on.

what i am going to do later tonight after i finish tilling the garden is start poking around at the internal antenna thing, my L400 to see if i can gently wiggle test to get shortwave to come in.


I had what i felt was an issue soldering a wire to L403,, its like the metal tang moved!  this little bugger is right on the band selector switch so i need to ohm check it as well.