Posts: 203
Threads: 20
Joined: Feb 2017
City: Orland Park
State, Province, Country: Illiinois
Ok! Today I got my variac, so I powered up slowly. The good news is, no smoke and nothing else visually seems to be an issue. The fuse I installed didn't blow.
The bad news is, it produces nothing but a steady hum, the volume knob appears to have no effect on it, and the display lamp doesn't light.
Where would you guys recommend I start checking? I have not replaced anything in this except caps and resistors, so everything else is original (including the long, tubular resistor).
Greg
"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."
Messages In This Thread
RE: Philco Model 20 Lowboy - by WallaceRoger - 05-05-2017, 08:12 PM
Users browsing this thread: 3 Guest(s)
|
Recent Posts
|
trying to identify this wire type
|
The red wire is rubber covered wire.
The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM |
trying to identify this wire type
|
Greetings Phorum members,
Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM |
Philco 60 Squealing
|
All correct shields must be in place, all tubes correct no subs of any kind.
Check any soldered, riveted ground conne...Chas — 01:24 PM |
Philco 60 Squealing
|
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM |
Philco 46-420 Code 121 Reception issues
|
Welcome Eric,
I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM |
Philco 46-420 Code 121 Reception issues
|
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM |
Philco 42-1008 conversion kit
|
Interesting. I haven't seen that before.klondike98 — 07:02 PM |
12' Philco
|
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM |
Shadow Meter Bulb
|
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM |
Shadow Meter Bulb
|
Ok. Thanks for the correction.RossH — 03:09 PM |
Who's Online
|
There are currently 4177 online users. [Complete List] » 2 Member(s) | 4175 Guest(s)
|
|
|
|