1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
PHILCO 91 225 IDENTIFICATION
SJHJR
Junior Member
**
Posts: 13
Threads: 3
Joined: May 2017
City: HAZLETON, PA
#3

05-06-2017, 11:33 PM
Thank you, Bob. I'm looking forward to doing a lot of research on this site, as well as research on how to make my flickr photos, public. I created an account, and tried adding links to my post, but it's not working.
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
PHILCO 91 225 IDENTIFICATION - by SJHJR - 05-06-2017, 09:58 PM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 05-06-2017, 10:28 PM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 05-06-2017, 11:33 PM
RE: PHILCO 91 225 IDENTIFICATION - by Ron Ramirez - 05-07-2017, 08:36 AM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 05-07-2017, 10:37 AM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 05-08-2017, 05:20 PM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 05-08-2017, 07:51 PM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 09-05-2018, 07:02 PM
RE: PHILCO 91 225 IDENTIFICATION - by morzh - 09-05-2018, 08:33 PM
RE: PHILCO 91 225 IDENTIFICATION - by klondike98 - 09-05-2018, 10:34 PM
RE: PHILCO 91 225 IDENTIFICATION - by Radioroslyn - 09-06-2018, 11:29 AM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 09-06-2018, 06:50 PM
RE: PHILCO 91 225 IDENTIFICATION - by Ron Ramirez - 09-06-2018, 07:03 PM
RE: PHILCO 91 225 IDENTIFICATION - by Radioroslyn - 09-06-2018, 07:16 PM
RE: PHILCO 91 225 IDENTIFICATION - by Ron Ramirez - 09-06-2018, 09:37 PM
RE: PHILCO 91 225 IDENTIFICATION - by Radioroslyn - 09-06-2018, 09:41 PM
RE: PHILCO 91 225 IDENTIFICATION - by SJHJR - 09-07-2018, 01:46 PM
RE: PHILCO 91 225 IDENTIFICATION - by OldRestorer - 09-08-2018, 09:03 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
My Philco 37-116 Restore
Hello MrFixr55, Thank you for taking the time to explain. I measured 50 volts where you say. Today the 370 volts at ...dconant — 12:51 PM
462ron
Oh that sucks. It’s something easily overlooked. Hopefully it’s nothing more than a resistor! Ron462ron — 08:08 AM
Philco 46-480 Electronic Restoration
Just confirmed that you are correct. It’s the function generator. I connected the signal output probe to one of the inpu...jrblasde — 07:52 AM
Philco 46-480 Electronic Restoration
Ouch, you may be right. Yes, it is solid state. It’s the signal output of my oscilloscope. May be time to crack that ...jrblasde — 07:27 AM
462ron
If you didn’t put a DC blocking cap between the signal generator probe and the plate of the 1st IF it’s possible you ble...462ron — 07:07 AM
My Philco 37-116 Restore
Hi DConnant, The reason why C127 is isolated from ground is because sets of this vintage did not have the center tap...MrFixr55 — 01:07 AM
Philco 46-480 Electronic Restoration
The shield is on the 6H6. It was, in fact, a missing jumper to connect the main chassis ground to the RF chassis grou...jrblasde — 10:58 PM
Zenith H725
When dealing with noise on power lines, time to get my Jackery 240 out. Talk about clean can hold a portable am radio ne...David — 08:52 PM
Zenith H725
Arran - I bet you're right probably vinyl, there was no rubber smell when desoldering it, which you often get with the o...EdHolland — 08:23 PM
Zenith H725
Ed; It was very likely vinyl covered wire given the vintage of the set, there was some rubber/gutta percha wire used ...Arran — 06:34 PM

[-]
Who's Online
There are currently 785 online users. [Complete List]
» 1 Member(s) | 784 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Home Radios