Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 640 or 650
#1

I recently purchased what was believed to be a Philco model 640B tombstone.  I do not have possession of it as of yet.  It has the strange "flat" band selector knob that appears to be on the model 640 sets.  However, it has an 8 tube chassis with what appears to be a driver stage tube.  Chassis looks to be a model 650.  I should have set later this week.  It may be a 650 that someone placed the wrong knob on??

 Did Philco place an 8 tube chassis is some of there model 640 sets?  


Thank you for any clarification you can offer.

Dave


Messages In This Thread
Philco 640 or 650 - by Dave Slusarczyk - 05-08-2017, 12:11 PM
RE: Philco 640 or 650 - by Ron Ramirez - 05-08-2017, 02:13 PM
RE: Philco 640 or 650 - by Dave Slusarczyk - 05-08-2017, 03:12 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 5394 online users. [Complete List]
» 1 Member(s) | 5393 Guest(s)
Avatar

>