Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Please ID this Silvertone
#6

I think I have still have a few of them around some where. Got to preheat them to avoid the crackels.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Please ID this Silvertone - by vecher - 05-22-2017, 11:42 PM
RE: Please ID this Silvertone - by OldRestorer - 05-23-2017, 12:11 AM
RE: Please ID this Silvertone - by vecher - 05-23-2017, 01:11 AM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 07:39 AM
RE: Please ID this Silvertone - by Eliot Ness - 05-23-2017, 08:37 AM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 09:13 AM
RE: Please ID this Silvertone - by sam - 05-23-2017, 11:19 AM
RE: Please ID this Silvertone - by OldRestorer - 05-23-2017, 04:09 PM
RE: Please ID this Silvertone - by Radioroslyn - 05-23-2017, 05:00 PM
RE: Please ID this Silvertone - by vecher - 05-23-2017, 08:38 PM
RE: Please ID this Silvertone - by vecher - 07-04-2017, 12:09 AM
RE: Please ID this Silvertone - by vecher - 07-04-2017, 08:32 PM
RE: Please ID this Silvertone - by Radioroslyn - 07-05-2017, 06:18 PM
RE: Please ID this Silvertone - by vecher - 07-05-2017, 11:28 PM
RE: Please ID this Silvertone - by Radioroslyn - 07-06-2017, 12:30 AM
RE: Please ID this Silvertone - by vecher - 07-07-2017, 12:08 AM
RE: Please ID this Silvertone - by vecher - 09-22-2017, 11:17 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM

[-]
Who's Online
There are currently 5721 online users. [Complete List]
» 1 Member(s) | 5720 Guest(s)
Avatar

>