Simpson 260 Battery Contacts

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Simpson 260 Battery Contacts

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

05-23-2017, 03:17 PM

Hey John I picked up a 260 abt 6-7yrs ago at a flea market. A later model model w/the little white button that jumps out when you measure volt on the ohm setting. This one was pretty clean and has the roll top case. Use it as my daily driver when servicing stuff.
Also have a Triplett 630 like it too as it can measure up to 6KV (for those estats TV's) but it use an odd 30v battery for the ohm section

Attached Files Image(s)

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Simpson 260 Battery Contacts - by Eliot Ness - 05-23-2017, 10:08 AM

RE: Simpson 260 Battery Contacts - by Radioroslyn - 05-23-2017, 03:17 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
Looking for verification of correct schematic.
Definitely 870044RossH — 01:12 PM
12' Philco
Wonder if the chassis was big too.daveone23 — 12:38 PM
Philco 38-2 Automatic Tuning
Hi Ron, I have sent Radio Daze my concerns with the dial so I guess we will see. They used my original to make the repro...dconant — 12:27 PM
Hickok AC51 tube tester
How does the 5W4 and 83 tube filaments get fed?martinj — 12:25 PM
462ron
Hi Dan, your original dial appears to be lighter, easier to allow light through. My original is similar except it’s crac...462ron — 12:07 PM
Philco 38-2 Automatic Tuning
I received my new 38-2 dial. I'm a little disappointed. As you can see in the picture the blues have a white shadow. The...dconant — 11:13 AM
Philco 38-2 Low Volume
I have been playing my 38-2 for a while now and it is doing very well. I did have to replace the 6A8 (osc) as it develop...dconant — 11:03 AM
Philco Speaker Spider
Hello, Does anyone with a 3 D printer make the spiders for those old Philco speakers? That might be a good idea for some...dconant — 09:41 AM
Philco 16B Parts
Hello, I'm looking to buy a 16B but I'm not so sure of what I am looking at. First as seen from the picture it looks lik...dconant — 09:17 AM
Looking for verification of correct schematic.
Klondike98, Thank you. I'll double check that SN and get back to you. GarySP, Thank you for the schematic.RossH — 12:13 AM

Who's Online

There are currently 1873 online users. [Complete List]
» 2 Member(s) | 1871 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me