Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Little help, Mike?
#2

BAD,

I saw that unit in my life; it was considered an upscaled portable. I never owned it.

I could post that question on the Ukrainian forum with Petro, see if someone replies.

My feeling is, the stereo button is pressed when you want the output going to an amp; the unit itself is likely incapable of reproducing stereo. Also the headphone output will be reproducing stereo.

The four buttons on top, left to right:

АПЧ - Авто Подстройка Частотьi (Auto Frequency Control), MП - местньй прием (Local Reception), УП - Узкая Полоса (Narrow Band), ШП - ШумоПодавитель (Noise Reducer).
Bottom knobs you know: Volume, Tone Ctl, Stereo.


Wires on the Converter:

Светльiй - Light-colored, Antenna Input (to your antenna).
Темньiй - dark colored, Antenna Output (to the radio's antenna input).
Провода Крепления (top of the picture, saying БК on one of them) - power battery minus
Красньiй - red, power battery plus.

if using power supply for the battery, it should be isolated.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
Little help, Mike? - by BrendaAnnD - 05-24-2017, 09:29 AM
RE: Little help, Mike? - by morzh - 05-24-2017, 12:02 PM
RE: Little help, Mike? - by RadioSvit - 05-24-2017, 05:35 PM
RE: Little help, Mike? - by RadioSvit - 05-24-2017, 05:52 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Need to purchase some accessories for restoration of my Old Philco Radio
Hi Paulo, Welcome to the Philco Phorum. I can see why you want to find good reproduction parts. That is a bea...MrFixr55 — 11:10 PM
HiFi (Chifi) tube amp build - but my own design.
Tim, I have some bakelite sockets in my work shop that I can dig up. I believe quite a few are NOS. I will take photo...RodB — 10:03 PM
Philco 610B oscillator wiring
> The cathode as noted is wired directly to the ground side of the heater filament for that tube, not to the #17 and ...Radioroslyn — 08:12 PM
HiFi (Chifi) tube amp build - but my own design.
Tim; I noticed your post a little late, but I would take one of the junk sockets and try to break a chunk out of it wi...Arran — 08:07 PM
Need to purchase some accessories for restoration of my Old Philco Radio
Here is a list of resources found in our online library that you might find useful. Mike's Gobs of Knobs email addres...klondike98 — 01:46 PM
First Radio restoration
Hi Tubeman, Welcome to the Philco Phorum.  Phamily Phriendly Pfun with Phine Pholks Phull of Philco Phacts. (See a p...MrFixr55 — 12:33 PM
First Radio restoration
You could post in the WANTED ADs section here on the Phorum and see if anyone has an RF generator that they want to sell...klondike98 — 11:55 AM
Zenith H725
Good ideas, thank you Arrange and Rich. I have the adhesive aluminum foil already and can try that immediately. More ...EdHolland — 10:18 AM
Graphics for majestic 1050 dial glass.
Murf; I found this thread on the ARF, the first photo has a pretty good view of the dial glass. Regards ArranArran — 01:12 AM
Zenith H725
hello Ed, how about that speacial tape used for ducting it's like foil or how about thin piece of aluminum roof flash...radiorich — 12:19 AM

[-]
Who's Online
There are currently 1369 online users. [Complete List]
» 1 Member(s) | 1368 Guest(s)
Avatar

>