Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 40-165
#12

Hey Jim,
Send me your mailing address via the private message or email and I'll drop you a new Stancor A3822 free. It's a multi match that is designed to match 7000 to 10K


Attached Files Image(s)
   

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 40-165 - by jmcgill - 06-02-2017, 08:10 PM
RE: Philco 40-165 - by Radioroslyn - 06-03-2017, 04:42 AM
RE: Philco 40-165 - by jmcgill - 06-04-2017, 05:13 PM
RE: Philco 40-165 - by Radioroslyn - 06-05-2017, 10:45 AM
RE: Philco 40-165 - by jmcgill - 06-05-2017, 01:42 PM
RE: Philco 40-165 - by morzh - 06-05-2017, 02:04 PM
RE: Philco 40-165 - by Radioroslyn - 06-05-2017, 04:05 PM
RE: Philco 40-165 - by jmcgill - 06-06-2017, 01:40 PM
RE: Philco 40-165 - by Radioroslyn - 06-06-2017, 04:12 PM
RE: Philco 40-165 - by jmcgill - 06-07-2017, 09:46 AM
RE: Philco 40-165 - by morzh - 06-07-2017, 10:42 AM
RE: Philco 40-165 - by Radioroslyn - 06-07-2017, 01:22 PM
RE: Philco 40-165 - by Ron Ramirez - 06-11-2017, 11:00 AM
RE: Philco 40-165 - by Radioroslyn - 06-11-2017, 11:14 AM
RE: Philco 40-165 - by jmcgill - 06-11-2017, 03:20 PM
RE: Philco 40-165 - by Radioroslyn - 06-11-2017, 04:03 PM
RE: Philco 40-165 - by jmcgill - 07-26-2017, 06:46 PM
RE: Philco 40-165 - by Radioroslyn - 07-26-2017, 07:26 PM
40-165 - by jmcgill - 06-11-2017, 09:45 AM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently no members online.

>