Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Need help finding a radio
#7

The 1939 models do not have built-in loop antennas as Greg has already mentioned above, therefore the cabinets are not as deep as are the 1940 and 1941 versions.

The 1940 and 1941 models will play the best, but beware the 1941 models are a nightmare to restore. All of them have rubber-covered wiring...but the wiring in the 41-250 and 41-255 is worse, especially around the band switch. You must be very careful around the band switch when rewiring a 41-250 or 41-255 - the band switch is very easily broken. Don't ask how I know. Icon_redface

--
Ron Ramirez
Ferdinand IN


Messages In This Thread
Need help finding a radio - by PhilcoJohn - 06-14-2017, 07:14 PM
RE: Need help finding a radio - by morzh - 06-14-2017, 07:27 PM
RE: Need help finding a radio - by Paul Philco322 - 06-14-2017, 08:30 PM
RE: Need help finding a radio - by morzh - 06-14-2017, 08:44 PM
RE: Need help finding a radio - by PhilcoJohn - 06-15-2017, 07:54 PM
RE: Need help finding a radio - by Ron Ramirez - 06-15-2017, 08:15 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>