42-390 and photofinish?

Register

Guest Join Us

Hello Guest,

Please feel free to join us!
There are many more parts of the Phorum that only members can see.

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

42-390 and photofinish?

Arran
Phorum Expert

Posts: 4,707
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA

#3

01-28-2010, 01:18 AM

If you were to stain the wood under the faux wood grain you would need to use a penetrating stain or an aniline wood dye, hardware store oil stain is not going to cut it with that hard grainless veneer.
Best Regards
Arran

Find

« Next Oldest | Next Newest »

Messages In This Thread

42-390 and photofinish? - by z-wave - 01-08-2010, 01:06 AM

Re: 42-390 and photofinish? - by gary rabbitt - 01-09-2010, 01:15 AM

Re: 42-390 and photofinish? - by Arran - 01-28-2010, 01:18 AM

Re: 42-390 and photofinish? - by gary rabbitt - 03-15-2010, 02:24 AM

Re: 42-390 and photofinish? - by TimC - 03-16-2010, 09:13 PM

Re: 42-390 and photofinish? - by gary rabbitt - 04-12-2010, 11:03 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5275 online users. [Complete List]
» 1 Member(s) | 5274 Guest(s)