1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 49-1611
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#2

06-20-2017, 05:10 PM
I think most would just solder in 4 separates. Some would take the can apart (grinding off the bottom flange removing the innards and resealing the bottom or cutting the side open abt an inch above the bottom clean it out put new caps in and close it up by wrapping a layer of al tape) and restuffing. Or : https://hayseedhamfest.com/pages/custom-can-capacitor
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 49-1611 - by sdman - 06-20-2017, 03:55 PM
RE: Philco 49-1611 - by Radioroslyn - 06-20-2017, 05:10 PM
RE: Philco 49-1611 - by KCMike - 06-20-2017, 06:17 PM
RE: Philco 49-1611 - by sdman - 06-20-2017, 07:08 PM
RE: Philco 49-1611 - by sdman - 06-20-2017, 07:08 PM
RE: Philco 49-1611 - by klondike98 - 06-20-2017, 07:35 PM
RE: Philco 49-1611 - by jcassity - 06-23-2017, 11:46 PM
RE: Philco 49-1611 - by Radioroslyn - 06-24-2017, 06:32 AM
RE: Philco 49-1611 - by WallaceRoger - 06-24-2017, 10:47 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM
HiFi (Chifi) tube amp build - but my own design.
Tim Well...a chassis is metal. Magnetic or not, it does not matter. A transformer has some hum to it. It is natural. Th...morzh — 08:40 PM
Hickok AC51 tube tester
I thought the 83 tube was bad because it looked white but it tests strong. Blue gassy though. I checked the fuse, it was...martinj — 08:37 PM

[-]
Who's Online
There are currently 2717 online users. [Complete List]
» 1 Member(s) | 2716 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration