|
41-280 some parts don't jive w/ schematic, picture included
02-01-2010, 06:14 PM
You should be able to fit them inside no problem. It is important that any of the old lead from the old cap are gone as they could short. You do have the new one connected properly. They won't get hot.
Terry When my pals were reading comic books I was down in the basement in my dad's workshop. Perusing his Sam's Photofoacts Vol 1-50 admiring the old set and trying to figure out what all those squiggly meant. Circa 1966 Now I think I've got! Terry
« Next Oldest | Next Newest »
Messages In This Thread
41-280 some parts don't jive w/ schematic, picture included - by Elrick - 01-31-2010, 03:03 PM
Re: 41-280 some parts don't jive w/ schematic, picture included - by 7estatdef - 02-01-2010, 11:42 AM
Re: 41-280 some parts don't jive w/ schematic, picture included - by Elrick - 02-01-2010, 02:57 PM
Re: 41-280 some parts don't jive w/ schematic, picture included - by Elrick - 02-01-2010, 05:02 PM
Re: 41-280 some parts don't jive w/ schematic, picture included - by 7estatdef - 02-01-2010, 06:14 PM
Re: 41-280 some parts don't jive w/ schematic, picture included - by codefox1 - 02-02-2010, 11:33 AM
Re: 41-280 some parts don't jive w/ schematic, picture included - by Chuck Schwark - 02-02-2010, 01:18 PM
Re: 41-280 some parts don't jive w/ schematic, picture included - by Elrick - 02-08-2010, 09:01 AM
Re: 41-280 some parts don't jive w/ schematic, picture included - by 7estatdef - 02-08-2010, 12:33 PM
Users browsing this thread: 1 Guest(s) |
