1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 89 veneer missing
Phlogiston
Radio-Fixer-Upper
*****
Posts: 2,118
Threads: 112
Joined: Jun 2010
City: Medford OR (OR what?)
#14

07-05-2017, 06:13 PM
If you are using Crystallac, yes. If you are using Por-o-pac, probably not.
"I just might turn into smoke, but I feel fine"
http://www.russoldradios.com/
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 89 veneer missing - by RadioDR401 - 03-07-2017, 09:00 PM
RE: Philco 89 veneer missing - by John Bartley - 03-08-2017, 08:12 AM
RE: Philco 89 veneer missing - by Steve Davis - 03-08-2017, 10:29 AM
RE: Philco 89 veneer missing - by Radioroslyn - 03-10-2017, 09:40 PM
RE: Philco 89 veneer missing - by Arran - 03-13-2017, 01:54 AM
RE: Philco 89 veneer missing - by Steve Davis - 03-13-2017, 10:29 PM
RE: Philco 89 veneer missing - by Arran - 03-13-2017, 10:43 PM
RE: Philco 89 veneer missing - by RadioDR401 - 03-14-2017, 11:42 AM
RE: Philco 89 veneer missing - by Steve Davis - 03-14-2017, 01:27 PM
RE: Philco 89 veneer missing - by Arran - 03-14-2017, 07:50 PM
RE: Philco 89 veneer missing - by RadioDR401 - 07-04-2017, 11:41 AM
RE: Philco 89 veneer missing - by Steve Davis - 07-04-2017, 02:07 PM
RE: Philco 89 veneer missing - by RadioDR401 - 07-05-2017, 04:28 PM
RE: Philco 89 veneer missing - by Phlogiston - 07-05-2017, 06:13 PM
RE: Philco 89 veneer missing - by RadioDR401 - 07-06-2017, 07:18 AM
RE: Philco 89 veneer missing - by Phlogiston - 07-06-2017, 10:33 AM
RE: Philco 89 veneer missing - by RadioDR401 - 08-29-2017, 12:40 PM
RE: Philco 89 veneer missing - by RadioDR401 - 09-09-2017, 03:33 PM
RE: Philco 89 veneer missing - by Phlogiston - 09-09-2017, 04:05 PM
RE: Philco 89 veneer missing - by Scott D - 09-09-2017, 05:15 PM
RE: Philco 89 veneer missing - by RadioDR401 - 03-05-2018, 05:09 PM
RE: Philco 89 veneer missing - by sdradioman - 03-05-2018, 10:07 PM
RE: Philco 89 veneer missing - by Radioroslyn - 03-05-2018, 11:46 PM
RE: Philco 89 veneer missing - by RadioDR401 - 03-06-2018, 10:49 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 5096 online users. [Complete List]
» 1 Member(s) | 5095 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration