Philco 41-280 code 121

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 41-280 code 121

Arran
Phorum Expert

Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA

07-06-2017, 06:13 PM

Mike;
I think these chassis used a pair of #41s for output tubes, so basically a 6K6 with an old style six pin base. The plate voltages are also not especially high, I believe its 180 volts max. But the small size may explain the failure rate of the output transformers in these things, I have a chassis from a Canadian version and someone replaced it with a Hammond one back in the 1950s or 60s.
Regards
Arran

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 41-280 code 121 - by morzh - 07-05-2017, 08:22 PM

RE: Philco 41-280 code 121 - by Arran - 07-06-2017, 06:13 PM

RE: Philco 41-280 code 121 - by GarySP - 07-06-2017, 07:26 PM

RE: Philco 41-280 code 121 - by morzh - 07-06-2017, 07:49 PM

RE: Philco 41-280 code 121 - by morzh - 07-06-2017, 10:29 PM

RE: Philco 41-280 code 121 - by morzh - 07-06-2017, 10:36 PM

RE: Philco 41-280 code 121 - by morzh - 07-06-2017, 10:41 PM

RE: Philco 41-280 code 121 - by morzh - 07-08-2017, 07:23 PM

RE: Philco 41-280 code 121 - by GarySP - 07-08-2017, 11:12 PM

RE: Philco 41-280 code 121 - by morzh - 07-08-2017, 11:21 PM

RE: Philco 41-280 code 121 - by morzh - 07-09-2017, 01:56 PM

RE: Philco 41-280 code 121 - by Radioroslyn - 07-09-2017, 03:58 PM

RE: Philco 41-280 code 121 - by morzh - 07-09-2017, 04:48 PM

RE: Philco 41-280 code 121 - by KCMike - 07-09-2017, 05:16 PM

RE: Philco 41-280 code 121 - by morzh - 07-09-2017, 05:33 PM

RE: Philco 41-280 code 121 - by morzh - 07-09-2017, 05:44 PM

RE: Philco 41-280 code 121 - by GarySP - 07-10-2017, 08:08 PM

RE: Philco 41-280 code 121 - by GarySP - 07-10-2017, 08:49 PM

RE: Philco 41-280 code 121 - by morzh - 07-10-2017, 09:40 PM

RE: Philco 41-280 code 121 - by morzh - 07-22-2017, 09:43 PM

RE: Philco 41-280 code 121 - by 462ron - 07-23-2017, 11:43 AM

RE: Philco 41-280 code 121 - by morzh - 07-23-2017, 01:33 PM

RE: Philco 41-280 code 121 - by Radioroslyn - 07-23-2017, 02:17 PM

RE: Philco 41-280 code 121 - by morzh - 07-23-2017, 07:30 PM

RE: Philco 41-280 code 121 - by morzh - 07-26-2017, 06:34 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me