Thread Rating:
  • 2 Vote(s) - 4.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Emerson 250AW restore
#15

pilot lights on all vacuum tube sets usually start bright and then become dimmer as the tubes begin to warm up. The point is to make the red jewel glow a little. positioning of the pilot lamp can, to a limited extent, make the jewel a little brighter or dimmer. I have not finished the cabinet restoration yet so I haven't put my chassis back into the cabinet, otherwise I could tell you more about how much you might be able to move the lamp around.


Messages In This Thread
Emerson 250AW restore - by klondike98 - 03-27-2017, 12:05 AM
RE: Emerson 250AW restore - by morzh - 03-27-2017, 08:21 AM
RE: Emerson 250AW restore - by OldRestorer - 03-28-2017, 05:04 AM
RE: Emerson 250AW restore - by PhilcoPhan1936 - 05-02-2017, 12:03 PM
RE: Emerson 250AW restore - by klondike98 - 05-02-2017, 12:48 PM
RE: Emerson 250AW restore - by PhilcoPhan1936 - 05-02-2017, 01:12 PM
RE: Emerson 250AW restore - by klondike98 - 05-02-2017, 01:22 PM
RE: Emerson 250AW restore - by Mondial - 05-02-2017, 02:13 PM
RE: Emerson 250AW restore - by klondike98 - 05-02-2017, 02:23 PM
RE: Emerson 250AW restore - by PhilcoPhan1936 - 05-02-2017, 02:25 PM
RE: Emerson 250AW restore - by Mondial - 05-02-2017, 02:32 PM
RE: Emerson 250AW restore - by klondike98 - 05-02-2017, 02:35 PM
RE: Emerson 250AW restore - by klondike98 - 05-02-2017, 02:37 PM
RE: Emerson 250AW restore - by mcusi - 07-08-2017, 07:34 PM
RE: Emerson 250AW restore - by klondike98 - 07-08-2017, 08:02 PM
RE: Emerson 250AW restore - by Radioroslyn - 07-08-2017, 09:16 PM
RE: Emerson 250AW restore - by mcusi - 07-10-2017, 06:19 AM
RE: Emerson 250AW restore - by klondike98 - 08-19-2017, 11:49 AM
RE: Emerson 250AW restore - by Radioroslyn - 08-19-2017, 12:09 PM
RE: Emerson 250AW restore - by Eliot Ness - 08-19-2017, 11:01 PM
RE: Emerson 250AW restore - by OldRestorer - 08-20-2017, 07:28 AM
RE: Emerson 250AW restore - by klondike98 - 08-20-2017, 11:50 AM
RE: Emerson 250AW restore - by klondike98 - 08-22-2017, 07:59 PM
RE: Emerson 250AW restore - by Eliot Ness - 08-23-2017, 08:47 AM
RE: Emerson 250AW restore - by OldRestorer - 08-23-2017, 09:38 AM



Users browsing this thread: 7 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>