Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

New member, with a new radio - 42-1011
#4

Thanks! Bob, I'm going to reach out to John and see what he has to say on the radio.

I've done a bit of reading already, and I did see many comments about Philcos of this generation sometimes needing a complete re-wire, so I'm prepared for that to be part of getting it back in operation. I realize this will certainly increase the cost of a resto, but with our plans for the radio, I think it's worth it to give it another 75 years of life.

I'm really happy with the condition of the cabinet after some initial cleaning. There's a more careful cleaning to be done, but other than replacing the speaker cloth, our plan is to leave it completely original.

Oh, and one other question I have - just to get an understanding of what we've acquired. Once we have it restored and working again, what kind of value would it have - given the original turntable is long gone?


Messages In This Thread
RE: New member, with a new radio - 42-1011 - by dgoerlich - 07-12-2017, 11:43 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

[-]
Who's Online
There are currently no members online.

>