Model 370 chairside

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Model 370 chairside

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

02-07-2010, 11:05 AM

Mine sez 230vdc from chaiss ground to pin two. Sent pic via your email as sometimes the phorun doesn't like the size of my files. Tnx for the update on the Gallery. Will be great to have in up and running again!
Terry

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

Model 370 chairside - by 7estatdef - 01-27-2010, 10:59 PM

Re: Model 370 chairside - by Ron Ramirez - 02-05-2010, 08:06 PM

Re: Model 370 chairside - by 7estatdef - 02-06-2010, 12:27 PM

Re: Model 370 chairside - by 7estatdef - 02-06-2010, 11:04 PM

Re: Model 370 chairside - by Ron Ramirez - 02-07-2010, 08:08 AM

Re: Model 370 chairside - by Ron Ramirez - 02-07-2010, 09:10 AM

Re: Model 370 chairside - by 7estatdef - 02-07-2010, 11:05 AM

Re: Model 370 chairside - by Ron Ramirez - 02-07-2010, 12:38 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 4934 online users. [Complete List]
» 1 Member(s) | 4933 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me