07-12-2017, 09:41 PM
>I measured the following # 7 108.5 Ohms ( in circuit cap read .47 ) This is not removing the ground ..
# 12 103.1 Ohms ( in circuit cap read .47 ) This is not removing the ground
# 17 123.4 Ohms ( in circuit cap read .47 ) This is not removing the ground
I'm a little confused did you measure from the end terminal to the 26 tubes plate pin (#2)? Seems like the coil resistance are a bit high I'm thinking abt 25 ohms or so.
Everything else looks good. Did you test the caps for leakage (7,12,17). You can test them in the set when you try to get it working. Symptom is low B+ on the 26 tubes.
# 12 103.1 Ohms ( in circuit cap read .47 ) This is not removing the ground
# 17 123.4 Ohms ( in circuit cap read .47 ) This is not removing the ground
I'm a little confused did you measure from the end terminal to the 26 tubes plate pin (#2)? Seems like the coil resistance are a bit high I'm thinking abt 25 ohms or so.
Everything else looks good. Did you test the caps for leakage (7,12,17). You can test them in the set when you try to get it working. Symptom is low B+ on the 26 tubes.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got it!
Terry
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
