PHILCO 296 Model H Speaker Question

Thread Rating:

WallaceRoger
Learn something new every day

Posts: 203
Threads: 20
Joined: Feb 2017
City: Orland Park State, Province, Country: Illiinois

07-14-2017, 01:24 PM

Terry and Mike will get you through it, have no fear. If you're an ace at reading schematics you're better off than I was a few months ago.

Greg

"We are here to laugh at the odds and live our lives so well that Death will tremble to take us."

Find

« Next Oldest | Next Newest »

Messages In This Thread

RE: PHILCO 296 Model H Speaker Question - by WallaceRoger - 07-14-2017, 01:24 PM

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM

Who's Online

There are currently 6305 online users. [Complete List]
» 2 Member(s) | 6303 Guest(s)