Hey guys...a little help!

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Hey guys...a little help!

Arran
Phorum Expert

Posts: 4,705
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA

07-15-2017, 11:31 PM

The pre war versions all have rubber/gutta percha covered wiring. You have two options with the dial, short of reproducing one yourself, (A) Buy one from Radiodaze (B) Find a junker set like yours with a broken cabinet but a good dial, which is also a way to find replacement knobs.
Regards
Arran

(This post was last modified: 07-15-2017, 11:38 PM by Arran.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

Hey guys...a little help! - by vinyl master - 07-10-2017, 10:45 PM

RE: Hey guys...a little help! - by PhilcoPhan1936 - 07-11-2017, 03:40 AM

RE: Hey guys...a little help! - by Ron Ramirez - 07-11-2017, 06:07 AM

RE: Hey guys...a little help! - by morzh - 07-11-2017, 08:03 AM

RE: Hey guys...a little help! - by PhilcoPhan1936 - 07-11-2017, 01:26 PM

RE: Hey guys...a little help! - by vinyl master - 07-13-2017, 03:35 AM

RE: Hey guys...a little help! - by Arran - 07-15-2017, 11:31 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me