Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 116PX is Home!
#18

It has been a while since I have been on the forum.  Life and the family seem to suck up a lot of my time.  

To start off with, yes I still have the Philco radio/phonograph combo.  It has been and still is one of my daily drivers both for the radio and the phonograph.  I finished the restoration last summer including restoration of the cabinet.  In a previous thread or PM, Ron had suggested the finish on this should be gloss, so that is what I did.  I will say, it turned out nice and works very well.  The "Slasher" Phonograph changer has only damaged or broken one record, which was my fault.  It was on the bench going through the paces and I was not paying attention.  Off the bench the record went.  Oh well, I guess that is why they have Polka Records. No offence to those who love Polka.  

To answer the question about the doors, yes the two side doors are for record storage.  You can store either 10 or 12 inch records no problem.  The doors use a piano hinge along the bottom.  The record compartment is about 7" deep with three  separate compartments about 2" wide.  On the sides of the compartment there is two wood dowels that stick out. This is to keep the door and records from falling to the floor when opened.   

I have posted some pictures to better show what I am talking about and of the finished Radio.

Hope this helps.


Attached Files Image(s)
                   


Messages In This Thread
Philco 116PX is Home! - by Skip - 03-29-2013, 09:49 PM
RE: Philco 116PX is Home! - by TA Forbes - 03-29-2013, 11:07 PM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 02-28-2017, 02:14 AM
RE: Philco 116PX is Home! - by morzh - 02-28-2017, 08:09 AM
RE: Philco 116PX is Home! - by OldRestorer - 02-28-2017, 08:33 AM
RE: Philco 116PX is Home! - by gregb - 02-28-2017, 10:03 AM
RE: Philco 116PX is Home! - by PhilcoJohn - 03-05-2017, 06:39 AM
RE: Philco 116PX is Home! - by theradiofox - 04-30-2017, 08:02 PM
RE: Philco 116PX is Home! - by morzh - 04-30-2017, 08:55 PM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 04-30-2017, 10:02 PM
RE: Philco 116PX is Home! - by theradiofox - 05-01-2017, 06:59 AM
RE: Philco 116PX is Home! - by Ron Ramirez - 05-01-2017, 10:45 AM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 05-01-2017, 11:46 AM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 05-01-2017, 12:13 PM
RE: Philco 116PX is Home! - by Ron Ramirez - 05-01-2017, 01:29 PM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 05-01-2017, 05:13 PM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 05-04-2017, 01:26 PM
RE: Philco 116PX is Home! - by Skip - 07-16-2017, 08:00 PM
RE: Philco 116PX is Home! - by WallaceRoger - 07-16-2017, 08:07 PM
RE: Philco 116PX is Home! - by PhilcoPhan1936 - 07-16-2017, 08:13 PM
RE: Philco 116PX is Home! - by Skip - 07-16-2017, 08:18 PM
RE: Philco 116PX is Home! - by Skip - 07-16-2017, 08:22 PM
RE: Philco 116PX is Home! - by morzh - 07-16-2017, 08:41 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently 3621 online users. [Complete List]
» 2 Member(s) | 3619 Guest(s)
AvatarAvatar

>