Philco model 50

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Philco model 50

Guest
Unregistered

02-09-2010, 06:14 PM

I am in the process of replacing all caps on this radio. I have come across some bakelight enclosed ones. Is there any way to actually read these, that is which end is positive, and which is negative? There is a center post in the middle, and a terminal on each side. I am familiar with the old paper, mica, electrolytic, but not these. Can anyone help me out? Thanks

« Next Oldest | Next Newest »

Messages In This Thread

Philco model 50 - by Guest - 01-15-2010, 04:08 PM

Re: Philco model 50 - by Ron Ramirez - 01-15-2010, 05:58 PM

Re: Philco model 50 - by Guest - 01-15-2010, 07:00 PM

Re: Philco model 50 - by Carl Travis - 01-15-2010, 11:53 PM

Re: Philco model 50 - by Guest - 01-16-2010, 01:09 PM

Re: Philco model 50 - by Guest - 02-09-2010, 06:14 PM

Re: Philco model 50 - by 7estatdef - 02-09-2010, 07:06 PM

Re: Philco model 50 - by Guest - 02-09-2010, 07:42 PM

Re: Philco model 50 - by 7estatdef - 02-10-2010, 03:42 PM

Re: Philco model 50 - by Joe Rossi - 02-11-2010, 12:23 PM

Re: Philco model 50 - by Guest - 02-12-2010, 01:52 PM

Re: Philco model 50 - by 7estatdef - 02-12-2010, 09:33 PM

Re: Philco model 50 - by Guest - 02-13-2010, 09:37 AM

Re: Philco model 50 - by Jim Berg - 02-13-2010, 01:35 PM

View a Printable Version

Users browsing this thread: 3 Guest(s)

Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me