116X Tuning cap removal

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

116X Tuning cap removal

Radioroslyn
Phorum Expert

Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

07-21-2017, 03:43 PM

I need to remove the tuning from my 116X to replace the rubber bushings under it. Mounting screws have copper braid solder to them and access is kinda tight. Is there an easy way or do I just remove the tone switch, loosen the band switch and volume control? Also looking for recommendation on which bushings to order from RR.

TNX

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

116X Tuning cap removal - by Radioroslyn - 07-21-2017, 03:43 PM

RE: 116X Tuning cap removal - by morzh - 07-21-2017, 04:14 PM

RE: 116X Tuning cap removal - by Nathan Slingerland - 07-21-2017, 04:20 PM

RE: 116X Tuning cap removal - by Radioroslyn - 07-21-2017, 04:54 PM

RE: 116X Tuning cap removal - by KCMike - 07-21-2017, 05:23 PM

RE: 116X Tuning cap removal - by Radioroslyn - 07-21-2017, 06:37 PM

RE: 116X Tuning cap removal - by KCMike - 07-21-2017, 07:13 PM

RE: 116X Tuning cap removal - by Radioroslyn - 09-08-2017, 10:07 AM

RE: 116X Tuning cap removal - by sam - 09-08-2017, 11:35 AM

RE: 116X Tuning cap removal - by Radioroslyn - 09-08-2017, 11:40 AM

RE: 116X Tuning cap removal - by sam - 09-08-2017, 11:43 AM

RE: 116X Tuning cap removal - by morzh - 09-08-2017, 01:50 PM

RE: 116X Tuning cap removal - by Radioroslyn - 09-08-2017, 05:23 PM

RE: 116X Tuning cap removal - by Radioroslyn - 09-22-2017, 06:09 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me