1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
ID on this one tuber...?
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#6

08-17-2017, 11:26 AM
Obtw I forgot the ant wire, it's the long white that is going diagonally across the bottom of the chassis.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
Find
« Next Oldest | Next Newest »


Messages In This Thread
ID on this one tuber...? - by klondike98 - 08-15-2017, 07:30 PM
RE: ID on this one tuber...? - by WallaceRoger - 08-15-2017, 08:06 PM
RE: ID on this one tuber...? - by Paul Philco322 - 08-15-2017, 09:48 PM
RE: ID on this one tuber...? - by Radioroslyn - 08-16-2017, 04:30 PM
RE: ID on this one tuber...? - by klondike98 - 08-17-2017, 01:03 AM
RE: ID on this one tuber...? - by Radioroslyn - 08-17-2017, 11:26 AM
RE: ID on this one tuber...? - by 462ron - 08-17-2017, 04:47 PM
RE: ID on this one tuber...? - by Arran - 08-17-2017, 06:34 PM
RE: ID on this one tuber...? - by Radioroslyn - 08-17-2017, 08:00 PM
RE: ID on this one tuber...? - by WallaceRoger - 08-17-2017, 08:35 PM
RE: ID on this one tuber...? - by klondike98 - 08-18-2017, 12:13 PM
RE: ID on this one tuber...? - by palegreenthumb - 08-18-2017, 11:39 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM

[-]
Who's Online
There are currently 5818 online users. [Complete List]
» 1 Member(s) | 5817 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)