1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
New chassis washers for a Philco 89
NostalgiaRadioTime
Super Moderator
******
Posts: 1,523
Threads: 240
Joined: Sep 2012
City: West Bend, Wisconsin
#2

08-25-2017, 06:40 PM
I seem to remember on mine I squared off two sides of the chassis spacers on the disc sander to get them to fit under the corner lip of the chassis. That's about 4 or 5 years ago now but as I recall the tabs under the chassis where the screws go into are a bit recessed and not flush with the bottom edges of the chassis. It's probably not the right way but it worked for me. Icon_thumbup
Greg V.
West Bend, WI
Member WARCI.org
Website Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: New chassis washers for a Philco 89 - by NostalgiaRadioTime - 08-25-2017, 06:40 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

[-]
Who's Online
There are currently 5289 online users. [Complete List]
» 1 Member(s) | 5288 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration