Philco 514

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 514

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

#63

08-27-2017, 08:23 PM

Ok,, So grounding radio Via the Ground plug on power cord had No difference.. I did notice the following..

If I put my hand over the firts RF tube the volume went way up Actually I could vary the volume by moving my hand closer and farther from top of tube. the 2nd and 3rd IF tubes behaved the same but not as load as the 1st one..

I tried to short wiper of the volume to where it connects to the Ant terminal No difference in volume..

When a antenna is hooked up to ant terminal it makes NO difference

I can only receive the one station near me.. I also tried changing the 26 tubes around in different sockets Still NO difference..

PS also have a medium hum out of speaker.. haven't adjusted the hum adjusters yet..

What to check next??

Skip...

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 514 - by vecher - 07-08-2017, 06:05 PM

RE: Need INFO Philco 514 - by Ron Ramirez - 07-08-2017, 06:44 PM

RE: Need INFO Philco 514 - by OldRestorer - 07-09-2017, 11:48 AM

RE: Need INFO Philco 514 - by Radioroslyn - 07-09-2017, 01:29 PM

RE: Need INFO Philco 514 - by vecher - 07-09-2017, 02:53 PM

RE: Need INFO Philco 514 - by Radioroslyn - 07-09-2017, 03:31 PM

RE: Need INFO Philco 514 - by vecher - 07-09-2017, 03:49 PM

RE: Need INFO Philco 514 - by Radioroslyn - 07-09-2017, 04:19 PM

RE: Need INFO Philco 514 - by vecher - 07-09-2017, 04:22 PM

RE: Need INFO Philco 514 - by Arran - 07-10-2017, 05:24 PM

RE: Need INFO Philco 514 - by vecher - 07-10-2017, 08:32 PM

RE: Need INFO Philco 514 - by sam - 07-10-2017, 10:17 PM

RE: Need INFO Philco 514 - by vecher - 07-11-2017, 12:11 AM

RE: Need INFO Philco 514 - by vecher - 07-11-2017, 06:30 PM

RE: Need INFO Philco 514 - by philco phan - 07-11-2017, 11:43 PM

RE: Need INFO Philco 514 - by Radioroslyn - 07-12-2017, 10:10 AM

RE: Need INFO Philco 514 - by vecher - 07-12-2017, 10:33 AM

RE: Need INFO Philco 514 - by Radioroslyn - 07-12-2017, 11:06 AM

RE: Need INFO Philco 514 - by vecher - 07-12-2017, 08:23 PM

RE: Need INFO Philco 514 - by Ron Ramirez - 07-12-2017, 08:33 PM

RE: Need INFO Philco 514 - by vecher - 07-12-2017, 08:34 PM

RE: Need INFO Philco 514 - by Radioroslyn - 07-12-2017, 09:41 PM

RE: Need INFO Philco 514 - by vecher - 07-12-2017, 10:57 PM

RE: Need INFO Philco 514 - by Radioroslyn - 07-12-2017, 11:23 PM

RE: Need INFO Philco 514 - by vecher - 07-13-2017, 09:39 PM

RE: Need INFO Philco 514 - by Radioroslyn - 07-14-2017, 05:35 AM

RE: Need INFO Philco 514 - by vecher - 07-14-2017, 11:53 PM

RE: Philco 514 - by vecher - 07-16-2017, 01:45 PM

RE: Philco 514 - by philco phan - 07-21-2017, 11:14 PM

RE: Philco 514 - by vecher - 07-21-2017, 11:31 PM

RE: Philco 514 - by philco phan - 07-21-2017, 11:41 PM

RE: Philco 514 - by vecher - 07-22-2017, 02:26 PM

RE: Philco 514 - by vecher - 07-22-2017, 03:37 PM

RE: Philco 514 - by philco phan - 07-22-2017, 04:38 PM

RE: Philco 514 - by vecher - 07-22-2017, 05:32 PM

RE: Philco 514 - by philco phan - 07-22-2017, 06:00 PM

RE: Philco 514 - by philco phan - 07-22-2017, 06:12 PM

RE: Philco 514 - by vecher - 07-22-2017, 07:50 PM

RE: Philco 514 - by vecher - 07-24-2017, 11:26 AM

RE: Philco 514 - by morzh - 07-24-2017, 11:46 AM

RE: Philco 514 - by vecher - 07-24-2017, 12:30 PM

RE: Philco 514 - by Jimmy Radionut - 07-24-2017, 12:47 PM

RE: Philco 514 - by WallaceRoger - 07-24-2017, 12:52 PM

RE: Philco 514 - by philco phan - 07-27-2017, 09:55 PM

RE: Philco 514 - by vecher - 07-27-2017, 11:12 PM

RE: Philco 514 - by philco phan - 07-28-2017, 12:27 AM

RE: Philco 514 - by vecher - 07-28-2017, 03:27 PM

RE: Philco 514 - by vecher - 07-30-2017, 11:09 PM

RE: Philco 514 - by philco phan - 07-30-2017, 11:42 PM

RE: Philco 514 - by vecher - 08-08-2017, 01:01 PM

RE: Philco 514 - by Radioroslyn - 08-08-2017, 01:11 PM

RE: Philco 514 - by vecher - 08-08-2017, 02:10 PM

RE: Philco 514 - by vecher - 08-10-2017, 10:51 AM

RE: Philco 514 - by Radioroslyn - 08-10-2017, 03:21 PM

RE: Philco 514 - by philco phan - 08-24-2017, 12:51 AM

RE: Philco 514 - by vecher - 08-24-2017, 08:53 PM

RE: Philco 514 - by philco phan - 08-24-2017, 10:04 PM

RE: Philco 514 - by vecher - 08-27-2017, 04:21 PM

RE: Philco 514 - by Radioroslyn - 08-27-2017, 04:36 PM

RE: Philco 514 - by vecher - 08-27-2017, 04:42 PM

RE: Philco 514 - by Radioroslyn - 08-27-2017, 04:58 PM

RE: Philco 514 - by vecher - 08-27-2017, 07:06 PM

RE: Philco 514 - by vecher - 08-27-2017, 08:23 PM

RE: Philco 514 - by philco phan - 08-27-2017, 09:17 PM

RE: Philco 514 - by vecher - 08-27-2017, 11:39 PM

RE: Philco 514 - by Radioroslyn - 08-28-2017, 12:27 AM

RE: Philco 514 - by vecher - 08-28-2017, 09:00 PM

RE: Philco 514 - by Radioroslyn - 08-28-2017, 09:11 PM

RE: Philco 514 - by vecher - 08-28-2017, 09:21 PM

RE: Philco 514 - by vecher - 08-29-2017, 03:03 PM

RE: Philco 514 - by vecher - 09-01-2017, 07:32 PM

RE: Philco 514 - by Ron Ramirez - 09-01-2017, 09:38 PM

RE: Philco 514 - by vecher - 09-01-2017, 09:40 PM

RE: Philco 514 - by vecher - 09-07-2017, 12:16 AM

RE: Philco 514 - by Radioroslyn - 09-07-2017, 01:03 AM

RE: Philco 514 - by Mondial - 09-07-2017, 08:19 AM

RE: Philco 514 - by vecher - 09-08-2017, 12:16 AM

RE: Philco 514 - by vecher - 09-09-2017, 12:19 AM

RE: Philco 514 - by morzh - 09-09-2017, 10:13 AM

RE: Philco 514 - by vecher - 09-09-2017, 09:14 PM

RE: Philco 514 - by Radioroslyn - 09-09-2017, 11:36 PM

RE: Philco 514 - by vecher - 09-10-2017, 02:34 PM

RE: Philco 514 - by vecher - 09-10-2017, 10:54 PM

RE: Philco 514 - by vecher - 09-11-2017, 08:33 PM

RE: Philco 514 - by vecher - 09-12-2017, 07:08 PM

RE: Philco 514 - by Ron Ramirez - 09-12-2017, 08:11 PM

RE: Philco 514 - by bdi1976 - 11-01-2020, 11:29 AM

RE: Philco 514 - by philco phan - 11-01-2020, 11:53 AM

RE: Philco 514 - by bdi1976 - 11-01-2020, 12:24 PM

RE: Philco 514 - by bdi1976 - 11-01-2020, 03:31 PM

RE: Philco 514 - by philco phan - 11-01-2020, 04:01 PM

RE: Philco 514 - by bdi1976 - 11-02-2020, 09:09 PM

RE: Philco 514 - by philco phan - 11-02-2020, 09:34 PM

RE: Philco 514 - by bdi1976 - 11-02-2020, 09:43 PM

RE: Philco 514 - by philco phan - 11-02-2020, 10:12 PM

View a Printable Version

Users browsing this thread: 10 Guest(s)

Recent Posts
Shadow Meter Bulb
Phorum members, I am trying to find the bulb # for PHILCO Shadow Meter part number 45-2180 that is from a 37-640 chassis...georgetownjohn — 06:53 PM
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM

Who's Online

There are currently 5616 online users. [Complete List]
» 2 Member(s) | 5614 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me