Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

AK model 42 antenna transformer
#4

Very nice Buick!
Still have the Falcon but for now I'm not driving do to some heath issues. Hopefully this will change in the next year or so but for now I'm to use an electrical term grounded.
Have had the Falcon since the late 80's and it needed a lot of work to get it roadworthy. Have driven it about 20k over the last 20yrs. The little 144cid is pretty tired and would like to upgrade it to a 200 at some point. It's been sitting in the garage since 2/15 undriven and needs some work to get it going again.

https://www.flickr.com/photos/42774321@N...ateposted/

Kobers was off of Montana Rd but the story I heard was that they were being charged an annual fee by the EPA per car  for hazardous waste. That made the business unprofitable and they folded up their tent. Probably in the early 90's.

Nice chatting I'll get it in the post in the next day or so.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
AK model 42 antenna transformer - by Steve D - 09-05-2017, 12:01 PM
RE: AK model 42 antenna transformer - by Steve D - 09-06-2017, 09:02 AM
RE: AK model 42 antenna transformer - by Radioroslyn - 09-06-2017, 11:36 AM
RE: AK model 42 antenna transformer - by Steve D - 09-07-2017, 03:52 PM
RE: AK model 42 antenna transformer - by Steve D - 09-12-2017, 11:12 AM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM

[-]
Who's Online
There are currently 5247 online users. [Complete List]
» 2 Member(s) | 5245 Guest(s)
AvatarAvatar

>